Portable generators never plug into a wall outlet, and standby units connect through a transfer switch installed at the panel. The electrician also picks the pad location, fuel connection and circuits to back up. Call the number on this page to be connected with a local electrician in Scottsdale.

Choosing a size that makes sense
Generator capacity is matched to what you want running at the same moment, not to the size of the house. Central AC takes the biggest share, and a pool pump, well pump or electric range add more. Electricians usually start from your must-run list and size up from there.
AC load is the sizing question
Central AC draws a large surge when the compressor starts, so a generator sized only for the running load may stall. Electricians check the AC's rating and may recommend a soft-start device to lower the surge. That one detail often decides whether a smaller unit works.
With a median build year of 1990, many homes here have older panels, so an electrician checks for room and breaker compatibility before planning a transfer switch.
Two utilities serve parts of Scottsdale, so outage reports and any utility paperwork depend on the name on your bill.
What you may not see in a brochure
Brochure prices cover the unit, not the pad, conduit, permits, switch, fuel line and commissioning. Ask for the full installed scope. Also ask about maintenance, such as periodic exercise runs and fluid changes, since upkeep is part of owning a standby system in Scottsdale.
Before electrical work starts in Scottsdale
Electric service here is split between APS and SRP, so check your bill before reporting an outage. APS's outage line is 602-371-3680.
If you see sparks, smoke or flames, or smell something burning from an outlet, switch or panel, get everyone out and call 911 before anything else. For a power line on the ground, stay at least 100 feet away, call 911, then call the utility.
Electrical permits for Scottsdale addresses go through Scottsdale's One Stop Shop permit center. Panel and service upgrades, new circuits and generator hookups usually need one, followed by an inspection.
In Arizona, electrical contractors need a license from the Registrar of Contractors (ROC). Residential electrical work falls under the R-11 class, and the ROC's online contractor search shows whether a license is active.
Service upgrades need the utility as well as the city or county: the utility disconnects and reconnects power and decides where the meter goes.
Electricians who take calls here often also work in Paradise Valley, Fountain Hills and Mesa.
How a generator job usually goes
- Site visit to check the panel, loads and placement
- Written scope with generator, switch and fuel plan
- Permit filed by the contractor
- Pad, conduit, wiring and switch installed
- Inspection by the permit office, then a test under load
Details vary with the unit and the property.
Extension cords and overloads
If you run a portable without an inlet, use heavy-duty outdoor-rated cords with enough capacity and keep them out of standing water. Do not exceed the generator's rating; an overloaded unit overheats and can damage appliances. A properly sized circuit setup avoids most of the cord problems people run into.
Generator Installation questions in Scottsdale
What is a transfer switch?
Can a generator run my central AC?
How do I avoid carbon monoxide problems?
Does the generator need natural gas?
More electrical services in Scottsdale
Generator Installation nearby
Helpful guides
Sources
Last updated: