Rewiring means replacing the cable, boxes and connections that carry power through a house, either in part or throughout. In Phoenix it is most common in homes from the 1940s through the 1970s. Call the number on this page to be connected with a local electrician in Phoenix.

What rewiring means
Rewiring replaces old branch circuits, the cable that runs from the panel to outlets, switches and fixtures. Some jobs cover a single room or an addition. Others strip a whole house. The right scope depends on what the wiring looks like behind the walls, not on the age of the house alone.
Signs the wiring may be at its end
- Two-prong outlets with no ground, or three-prong covers wired to nothing
- Cloth-covered or brittle, cracked cable found in an attic or a switch box
- Breakers that trip whenever the microwave and AC run together
- Warm plates, a burning odor or flickering lights on a whole circuit
- A fuse box that has been patched with extra circuits over the decades
ESFI lists a burning odor, discolored plates and sparks as signs of serious wiring trouble. If you see sparks or smell smoke, leave and call 911 before anything else.
How Phoenix homes wear out their wiring
Neighborhoods built in the 1940s through the 1960s often still have original cable and small services. Attics in this climate get extremely hot for months, which dries and cracks insulation on cable that was never meant for that. Add a modern load of window units, a pool pump and a home office, and old circuits run closer to their limit than the original builder planned. Homes with aluminum branch wiring from about 1965 to the mid-1970s are a special case, covered on our aluminum wiring repair page.
How the job goes
An electrician starts by testing circuits and opening a sample of boxes to see what is actually there. Walls in stucco and block homes are harder to open than frame walls, so many jobs run cable through attics and crawl spaces and patch only where needed. Phoenix Planning and Development lists rewires among the electrical work that can be permitted over the counter, and anything that adds to or changes wiring needs a permit. Expect an inspection before walls are closed up.
What it costs
There is no solid whole-house figure to quote here, because the national range we found describes partial jobs. A Phoenix guide puts electrician labor at roughly $40 to $100 an hour, and another at $50 to $150. Rewiring is usually priced by scope after a walk-through, so compare written scopes, not just totals. Drywall and paint repair may be billed separately.
Check the ROC license
A rewire needs a permit, so the small-job exemption does not apply. Ask for the ROC number and confirm it covers residential electrical work, class R-11 or dual CR-11, using the free search on the Arizona Registrar of Contractors site.
Home Rewiring questions from Phoenix homeowners
Does my Phoenix house need rewiring?
Do I need a permit to rewire?
Can I stay in the house during rewiring?
Is cloth-covered wiring dangerous?
Related electrical services in Phoenix
Helpful guides
Home Rewiring in nearby cities and towns
Maricopa County
Pinal County
Sources
Last updated: