Electrician referrals for Phoenix & nearby townsCall: (602) 584-7286
(602) 584-7286

How much does an electrician cost in Phoenix?

electricianphoenixaz.net

Phoenix electrician pricing comes down to an hourly rate, a minimum call-out fee and a per-job range that depends on the work. This guide collects published figures and explains what pushes a job toward the high or low end.

Need an electrician now?
Call now to be connected with a local electrician in Phoenix.
(602) 584-7286

Phoenix electrician pricing comes down to an hourly rate, a minimum call-out fee and a per-job range that depends on the work. This guide collects published figures and explains what pushes a job toward the high or low end.

Quick cost estimator

Typical ranges from the sources cited below, not a quote. The company you hire will price the actual job.

The short answer

Published Phoenix cost guides put electrician labor at roughly $40 to $100 per hour (HomeGuide) or $50 to $150 per hour (Angi). HomeGuide lists an average minimum call-out fee of about $75. Most real jobs are priced per job rather than by the hour, and the ranges below show how wide that gets. Every figure is a published range from a cost guide, not a quote, and your own job can fall outside it.

Electrician Phoenix is a free referral service, not an electrical contractor. The electrician you are connected with sets the price for your job, so use this guide to judge whether a number is in the normal range.

Call now to be connected with a local electrician in Phoenix.
(602) 584-7286

Hourly rates and call-out fees

The two Phoenix hourly ranges overlap but are not identical, which is normal: each guide draws on different survey data. A call-out fee covers the trip and the first look at the problem, and some electricians apply it toward the repair if you go ahead. Ask on the phone whether the fee is credited and what the hourly rate is after the first visit.

Hourly pricing tends to apply to open-ended troubleshooting, where nobody knows the cause yet. Once the fault is found, a fixed price for the repair is common. Our troubleshooting service page explains how tracing a fault usually goes.

Typical per-job ranges in Phoenix and nationally

The table lists published ranges. The area column matters: Phoenix rows come from Phoenix-specific cost guides, and national rows are nationwide averages that may run a little different in the Valley.

JobRangeArea
Add an outlet$125 to $200 per outletPhoenix
Outlet or switch install or repair$155 to $547 per jobPhoenix
Panel replacement$450 to $2,110Phoenix
Meter box$100 to $650Phoenix
Hot tub or spa wiring$800 to $1,600Phoenix
GFCI outlet$130 to $300 per outletNational
Recessed light$100 to $300 per fixtureNational
Whole-home surge protector$200 to $800National
Electrical inspection$100 to $400National
EV charger install$551 to $1,384National
Whole-house generator$1,538 to $8,821National

What moves a job toward the high end

The same task can price very differently from house to house. In the Phoenix area, the usual reasons are these:

  • Access: a hot attic or a tight crawl space slows the work, and stucco walls make running new cable harder.
  • Panel capacity: a full panel or a small older service may need an upgrade before the new circuit can go in.
  • Distance: a long run to a detached garage, casita or pool equipment pad costs more than a short one.
  • Permits and inspection: jobs that need a city permit add paperwork and an inspection visit.
  • Materials: copper wire prices, equipment brands and whether the fixture or charger is supplied by you or the electrician.

Older homes often add cost because the electrician finds things that have to be corrected first. A house with two-prong outlets, an old fuse box or aluminum branch wiring can turn a simple request into a larger project, which is why a pre-work electrical inspection can be worth it.

Panels, service and meters cost more

Work at the panel and meter is the most expensive routine electrical job, and it involves more than one party. The electrician handles everything past the meter, while APS or SRP controls the meter and the connection to the street. A permit is normally needed too. For the details, read about panel upgrade costs by amp size and the service upgrade process.

Heat, pools and new loads in Phoenix pricing

Several Phoenix-specific jobs show up on estimates. Dedicated circuits for AC units and mini-splits are common, and an AC wiring and dedicated circuit job may need a heavier wire and a disconnect near the condenser. Pool and spa electrical includes bonding and GFCI protection, which is why spa wiring has its own row. Adding an EV charger is another frequent request. The national range of $551 to $1,384 is for most projects, and a house with a full panel may fall above it. See the Arizona EV charger guide for panel and permit steps.

How to compare estimates

Get the scope in writing before comparing numbers. Two estimates can differ because one includes the permit and the other does not, or because one replaces a breaker and the other replaces the whole panel. Ask each electrician:

  1. What is included: materials, permit fee, cleanup and wall patching?
  2. Is the call-out fee credited toward the job?
  3. Will the work be inspected by the city or county, and who arranges it?
  4. What is the ROC license number?

Worked examples: reading the ranges

A homeowner who wants two added outlets in a kitchen is looking at the Phoenix per-outlet range of $125 to $200 each, so roughly $250 to $400 before any wall repair or permit. A homeowner with a dead outlet may only need the $155 to $547 outlet and switch repair range, and the low end usually means a quick swap with an easy fault. Someone adding a spa to a backyard should expect the spa wiring range of $800 to $1,600 in Phoenix, and the pool equipment pad, bonding and GFCI protection are part of why that row is higher than a plain outlet.

These examples add published ranges together, so treat the result as a ballpark. A house that needs a panel upgrade before the new circuit can go in will land well above the sum.

Repair or replace: where the money goes

Small repairs have a floor set by the call-out fee and the first hour. After that, the choice between repairing and replacing matters. A warm or damaged outlet is a modest swap, but a scorched panel, a failing breaker that keeps tripping or a cracked meter base can lead to a larger replacement. Ask the electrician to explain why a repair will or will not hold. Our electrical repair page lists the common faults, and the outlet and switch repair page covers the most common small job.

Seasonal factors in the Valley

Summer is the busy season for electricians. Air conditioners push circuits and panels hard, and monsoon storms add surge damage and storm repairs. Scheduling a non-urgent job in cooler months can ease the wait, and attics are more bearable then, which helps with labor on recessed lighting, fans and rewiring. Planning ahead for a charger or a spa also leaves time for permits.

Check the ROC license, whatever the price

The Arizona Registrar of Contractors says a contractor holding an ROC license for residential electrical work uses class R-11, while C-11 covers commercial work and CR-11 covers both. The ROC contractor search on roc.az.gov is free. Work is exempt from an ROC license only when labor and materials total $1,000 or less, and any project that needs a municipal permit is not exempt at any price. A very low bid with no license number is a warning sign. Our ROC license checking guide shows what to look up.

Urgent jobs and after-hours calls

If something is smoking, sparking or hot, leave the house and call 911 before anything else. Once the situation is safe, an emergency electrician may charge more for after-hours work, so ask about that on the call. Many electricians take after-hours calls, but there is no promise of timing from this site.

Cost help by town

Prices do not vary wildly across the Valley, but travel and permit rules do. Permit offices differ in Phoenix, Mesa, Scottsdale and the smaller towns, so check the page for electricians serving Mesa or browse every town in our service area for local permit and utility details. You can also compare the full list of electrical services.

Bottom line

Expect hourly rates in the range of $40 to $150, a call-out fee near $75, and per-job prices that depend on the panel, the distance and the permit. Treat the table as a sanity check, get the scope in writing, and confirm the ROC number before anyone starts work.

Frequently asked questions

What is the hourly rate for an electrician in Phoenix?
Published Phoenix cost guides list about $40 to $100 per hour (HomeGuide) and $50 to $150 per hour (Angi). Rates vary with the type of work and the time of day.
Is there a minimum fee just for showing up?
HomeGuide lists an average minimum call-out fee of about $75 for Phoenix. Ask whether the fee is credited toward the repair.
How much does a panel replacement cost in Phoenix?
Angi lists $450 to $2,110 for a panel replacement in Phoenix. Upgrades in amp size or meter work can cost more.
Does the referral service charge anything?
No. Electrician Phoenix is a free referral service. You pay only the electrician for the work you agree to.
Do the listed ranges include permits?
Not necessarily. Many cost guides leave permits out, so ask each electrician whether the permit fee and inspection are in the price.
Call now to be connected with a local electrician in Phoenix.
(602) 584-7286

Last updated:

☎ Call (602) 584-7286