Hardwired smoke detectors connect to the home's power, usually with a battery backup, and can be linked so one alarm sounds them all. An electrician can add them to bedrooms and hallways or swap out old units. Call the number on this page to be connected with a local electrician in Phoenix.

Hardwired versus battery alarms
A battery-only alarm depends on you changing the battery. A hardwired unit takes power from a household circuit and typically keeps a battery as backup. Interconnected units signal each other through a wire or a wireless link, so an alarm in the garage is heard in the bedroom. In a large Phoenix single-story ranch or a two-story stucco home, that matters.
Signs it is time to replace or add alarms
- Units that chirp, even with fresh batteries
- Alarms that are yellowed, old or of unknown age
- No alarm in a bedroom, hallway or on every level
- A remodel or casita with no new alarms
- Nuisance alarms near the kitchen or a bathroom
Check the date printed on the back of each alarm and replace units that are past their rated life. The manufacturer's instructions give that life.
If an alarm sounds
An alarm is a reason to leave. The City of Mesa fire department says that if you see flames or smell smoke, leave immediately and dial 9-1-1. If you notice sparks, a burning smell or a hot outlet without any alarm, do the same. Do not stop to look for the cause.
How the job goes
When replacing an existing hardwired alarm, an electrician matches the connector, tests the interconnect and checks the circuit. Adding new alarms means running cable, often through a hot attic, and tying into a circuit. That is wiring work. If a permit is required for new wiring, City of Phoenix Planning and Development says work that adds to premises wiring needs one.
Phoenix details
Attic heat shortens the life of electronics, and dust can set off sensitive alarms, so units in garages and near AC returns need extra thought. Older Phoenix homes may have no hardwired alarms at all, and the ceiling may not be easy to fish. An electrician can often use existing circuits and wireless interconnect to avoid opening more of the ceiling than necessary.
What it costs
National figures put a hardwired smoke detector unit at about $15 to $80 per fixture, with labor extra. Total price depends on how many alarms, how hard the attic is to reach and whether new cable is needed. A Phoenix guide lists a service call around $75 and hourly rates from $40 to $100, so ask for a clear total.
Check the ROC license
Small jobs can fall under the ROC exemption of $1,000 or less in labor and materials, but anything needing a permit does not. Ask for an ROC license number and look it up on the Arizona Registrar of Contractors site.
Smoke Detector Installation questions from Phoenix homeowners
Should smoke detectors be hardwired?
Can an electrician replace my existing alarms?
How much does a hardwired alarm cost?
What if an alarm goes off?
Related electrical services in Phoenix
Helpful guides
Smoke Detector Installation in nearby cities and towns
Maricopa County
Pinal County
Sources
- HomeAdvisor: How Much Does Smoke Detector Installation Cost in 2025?
- City of Mesa Fire and Medical: Fire FAQs
- City of Phoenix Planning and Development: electrical permit requirements
- Angi: Phoenix, AZ electrical panel replacement cost
- Arizona Registrar of Contractors: License Classifications
- Arizona Registrar of Contractors: Contracting in Arizona
Last updated: